-40%

SNO-WAY SNOWAY Controller Keypad Repair Kit 96107354 96107355

$ 3.95

Availability: 78 in stock
  • Item must be returned within: 30 Days
  • Refund will be given as: Money Back
  • Returns Accepted: Returns Accepted
  • Return shipping will be paid by: Buyer
  • Restocking Fee: No
  • Manufacturer Part Number: Does Not Apply
  • Condition: New
  • Brand: ButtonWorx
  • Part Type: Snoplow Control
  • Interchange Part Number: 96107354

    Description

    ButtonWorx Button Repair Pad
    SNO-WAY
    ButtonWorx membrane repair is installed between the original rubber pad and circuit board.
    Permanent Repair
    Lasts longer than original buttons
    Seals out dirt and oils
    Easy put in place
    Satisfaction Guaranteed!
    Installation
    IMPORTANT
    :
    The red and black power wires from the battery pack will break off easily if you bend, tug and pull on them.  You must be extremely careful with the wires, especially if you cannot solder them back on yourself if they break off.
    A T-7 Torx bit is needed to take the back cover off.
    Also remove the battery cover and batteries.
    Peel brown paper off membrane.
    It can be difficult to start and you may want to use a sharp blade to grab an edge.
    Once you have an edge, the thin brown paper comes off
    very
    easily
    .
    If the paper is not removing easily then you are probably peeling the multi-layer keypad apart!!
    Use the holes to line up the keypad.
    The membrane pad should be installed AS FLAT AS POSSIBLE !!
    DO NOT press down hard. Just put in place. The adhesive will keep the pad from moving as soon as it touches.
    -
    The rubber keypad has 4 pins that poke through holes on the PCB
    The PCB needs to be tucked under the battery wires.
    The PCB has 4 larger holes that line up with some short posts on the top plastic housing.
    There is a small plug for the hole in wireless units